In your shopping cart: 0 Article, 0,00 EUR
TomTom XL vs2
Make fit
Preparation
Prior to using the ZunZun basic can easily be adapted once to your TomTom XL vs2. Do this at your convenience at home with your navigator within reach.
Follow the steps below. Click on a photo to enlarge.
Step 0. Remove InformationStrip
Remove the infostrip of the ZunZun.
Remove any cutting leftovers from the holes of the product, except parts Q.
Step 1. Prefolding
Fold the ZunZun 6x along the folding lines marked with letters D and H.
Fold towards yourself if the letters are visible. The resulting folds will be straight when you fold on a flat plane, for example a table.
Step 2. Shortening Flaps
Not applicable for the TomTom XL vs2.
Step 3. Cut a hole for the On/Off button (optional)
Cut out the area indicated with letter S1 for the On/Off button of your TomTom XL vs2.
Step 4. Assemble the Rubber Band
Assemble the rubber band on both flaps acoording to method X.
See the picture on the right for 1 flap. Assemble the other side of the rubber band to the second flap.
The assemblymethod X for the rubber band is also indicated on the flaps themselves.
Step 5. Mounting the ZunZun
Mount the ZunZun on your TomTom. Make sure the rubber band is placed both in front and behind the 2 lower corners of the TomTom-housing. See the picture on the right.
Attention: Safety!
Do not pay any attention to the ZunZun while driving.
While mounting or removing the ZunZun your car must be standing still in a safe place.
.
